Suction Housings
Items:
1–32 of 32,
per page
-
-
- This custom fitting, filled Hand hole cover is designed for RACE USE ONLY.
- The cover fits the contour inside of the suction housing almost perfect thus leaving no room for air to get trapped around the cover that creates cavitation
- (Requires machining locator nub out of suction housing)
- Fits Berkeley JC and Berkeley JG jet drive pumps
-
- Helps load the pump with water
- Well suited for 500+ h.p. boats
- Mounting hardware is included (4 nuts and bolts)
Available in V-Bottom or Tunnel Hull
-
- Extreme duty suction housing
- Extra gussets in the bearing housing area for added strength
- Has extra heat treating process reduces hydrogen embrittlement
- Hand hole opening is not machined — Machining is extra
-
- Extreme duty suction housing
- Extra gussets in the bearing housing area for added strength
- Hand hole opening is not machined — Machining is extra
If you are looking for a suction housing that has a heat treating process to reduce hydrogen embrittlement click here
-
- Mount the pump suction housing to the intake
- Kit Comes complete with hex head cap screws, lock washers, and washers
-
-
-
-
-
-
-
-
-
- 3/8"-16
- Made of stainless steel
- Sold by the each
Need a complete kit?
Click on Rod end hand hole cover kit.
-
- 3/8" Heavy Duty Hand Hole Cover Eye Bolts are Recommended for use on "RACE Application Pumps"
- Fits Berkeley pumps and American Turbine SD312 jet pumps
- Includes:
- Billet eye bolts
- Clevis Pins
- Cotter Pins
- Thick Washers
- Lock Washers
- Wing Nuts
-
- Hand hole cover O-ring
-
-
-
-
-
-
- This is the piece that is behind the thrust bearing
- It usually breaks due to over tightening
- Billett aluminum
- Sold per pair
-
-
-
-
-
-
-
-
-