Fastener Kits
Items:
1–12 of 12,
per page
-
These 3/8" Heavy Duty Hand Hole Cover Eye Bolts are Recommended for use on "RACE Application Pumps" Kit comes complete with Billet eye bolts, Clevis Pins, Cotter Pins, Thick Washers & Wing Nuts.
-
- Polished stainless steel for your marine engine
- Intake manifolds
- Valve covers
- Filler necks
- Timing covers
- Fuel pumps
- Distributor hold-downs
- Water pumps
- Oil pans
- Header bolts
- Polished stainless steel for your marine engine
-
- High compression nylon fuel bowl washers are unaffected by fuel and alcohol
- Will not tear or deteriorate like standard fiber washers
-
- 3/8" Heavy Duty Hand Hole Cover Eye Bolts are Recommended for use on "RACE Application Pumps"
- Fits Berkeley pumps and American Turbine SD312 jet pumps
- Includes:
- Billet eye bolts
- Clevis Pins
- Cotter Pins
- Thick Washers
- Lock Washers
- Wing Nuts
-
- Stop stripped threads due to frequent wedge changes
- Machined from stainless steel & have a nice bullnose end.
- Most applications will use 3" lengths, if using a wedge more than 4° you should order the 4" lengths
- 5/16"-18 Thread
- We recommend Moly Paste on the threads so galling does not occur.
-
- Grade 8 bolts are long enough to double nut your loader in place
- Includes 4 Bolts and 8 locking nuts
-
- Reduce the chances of blowing the bowl off of your jet and eliminates stripped bowl threads
- This kit is a substitute for having your bowl double bolted
- 2-1/2" Overall length
- Made of 18-8 stainless steel
- One end has a bullnose
- 1/2"-13 Thread
Kit Includes:
- 8 Studs
- 8 nuts
- 8 lock washers
-
- Easy to install bolt kit replaces every bolt that assembles your Berkeley jet drive
- Includes:
- 8 Bowl Bolts
- 4 Bearing Cap Bolts
- 3 Pin Bolts
- 2 Packing Gland Bolts
- 2 Packing Nuts
- 14 Intake Bolts
- 14 Intake Lock Washers
-
- All new stainless hardware to install your Berkeley transom assembly.
- Includes
- 8 Flat Head Bolts (1/4"-20 x2")
- 2 Flat Head Screws (#14 x1-1/2")
- 8 Lock Washers (1/4)
- 8 Washers (1/4")
- 8 Nuts (1/4"-20)
-
- Mount the pump suction housing to the intake
- Kit Comes complete with hex head cap screws, lock washers, and washers
-
- Secures the intake in the bottom of the boat after the epoxy has cured
- Includes: 18. 1/4" dia flat head phillips machine screws, lock washer, nuts, and washers
-
- All new stainless hardware to install your Shoe and Ride Plate Kit.
- Includes
- 9 Flat Socket Head Screws
- 2 Flat Socket Head Screws "Long"
- 2 Hex Head Screws
- 2 Socket Head Screws "Short"
- 4 Nuts
- 2 Lock Nuts
- 4 Flat Washers
- 4 Lock Washers